alberta heart institute square

Mazankowski Alberta Heart Institute

  • Alberta heart institute

    Image Credit: EllisDon

  • Alberta heart institute 2

11220 83 Ave NW, Edmonton, Alberta
8 Storeys
General Contractor: EllisDon
Pro-Bel services provided: Design, Engineer, Manufacture, Supply and Install


The Mazankowski Alberta Heart Institute (MAHI), a $196 million, 9 storey "hospital within a hospital" was named after the Right Honourable Don Mazankowski, former Deputy Prime Minister of Canada, active Conservative politician and businessman. The Institute is a world-class centre of excellence in paediatric and adult heart disease prevention, treatment, research, and education. The MAHI establishes a separate identity from a cluster of hospital buildings while maintaining a connection, both physically and visually, to the main hospital - the Walter C. Mackenzie Health Sciences Centre. Symbolic of the heart institute is a towering curtain of glass that curves around the south wall. The roof of the building features a heliport and roof garden with specially designed safety nets around the helicopter landing pad.

Pro-Bel Technical Approach

The suspended maintenance and fall protection requirements on the MAHI project included: monorails for cleaning interior atrium glass and maintaining electrical and mechanical appurtenances; horizontal cable lifelines for travel on the roof and to safely access work stations (davit locations); both roof rigged and ground rigged davit arms; platform stabilization buttons; and u-bar safety anchors.

A unique feature of the suspended maintenance plan involved designing a davit base system with careful consideration as to how the davits would be used for lifting the platforms for window cleaning/exterior building maintenance. This was due to the sloped roof edges and the helicopter pad which had near-horizontal safety grating/netting around the pad, close to the edges of the roof. This confined area would not permit the use of roof rigged davits. As a result, ground rigged davit arms were designed to go behind and between the safety grating sections - an unusual situation - ultimately and successfully sorted out by the Pro-Bel engineers.

For exterior platform work, stabilization buttons (detent pins) were installed on the window mullions of the exterior building every third floor. Stabilization of a platform, cage or boson\'s chair equipment is a system designed to keep the equipment in contact with the building\'s façade, to prevent movement. Without stabilization, worker safety could be in jeopardy due to wind action or building faces could become damaged due to equipment impact.


Related Equipment