Roof Anchors – Cast In Place – 1 Piece Fully Embedded
- The standard height of a fully embedded roof anchor is 18 and 24 inches.
- This anchor suits all 3-1/2 inch conventional flashings.
- Using a fully embedded anchor is more cost-effective than a single stud or a four-stud anchor of the same finished height.
- The base Plate of this anchor MUST sit on top of the bottom reinforcing bar.
- The general contractor must provide the bottom re-rod steel location and the slab thickness at each anchor location to determine the total anchor height.
Download our Safety and Tie Back Anchors Brochure here for more information.
See Product Size Variations below.
For further inquiry on this product, please contact us at 1800 461.0575
Description
Product Size Chart
Below is a chart of our standard sizes. More are available upon enquiry.
| Model No. | Anchor Height | Slab Thickness Min. | Critical Embed Depth | Add Ins | Flashing Type | Flashing Height |
| EF-FA-PBE74EBD-1506 | 15″ | 5-1/2″ to 7″ | 4-1/2″ to 6″ | None | ||
| FA-PBE74EBD-1806 | 18″ | 5-1/2″ to 7″ | 4-1/2″ to 6″ | None | ||
| FA-PBE74EBD-1806-FL1 | 18″ | 5-1/2″ to 7″ | 4-1/2″ to 6″ | Flashing | Conventional | 8″ |
| FA-PBE74EBD-2006 | 20″ | 7″ | 6″ | None | ||
| FA-PBE74EBD-2006-FL1 | 20″ | 7″ | 6″ | Flashing | Conventional | 8″ |
| FA-PBE74EBD-2006-FL2 | 20″ | 7″ | 6″ | Flashing | Conventional | 11″ |
| FA-PBE74EBD-2406 | 24″ | 7″ | 6″ | None | ||
| FA-PBE74EBD-2406-FL1 | 24″ | 7″ | 6″ | Flashing | Conventional | 8″ |
| FA-PBE74EBD-2406-FL2 | 24″ | 7″ | 6″ | Flashing | Conventional | 11″ |
| EF-FA-PBE74EBD-2606 | 26″ | 7″ | 6″ | None | ||
| EF-FA-PBE74EBD-2806 | 28″ | 7″ | 6″ | None | ||
| FA-PBE74EBD1-3006 | 30″ | 7″ | 6″ | None | ||
| FA-PBE74EBD1-3006-FL3 | 30″ | 7″ | 6″ | Flashing | Conventional | 8″ |
| FA-PBE74EBD1-3006-FL4 | 30″ | 7″ | 6″ | Flashing | Conventional | 11″ |
